Interface Modules


 
RECEIVER-SDI2
  • Dual internal antennas provide spatial and polar RF signal reception for high reliability
  • Cover and wall tamper protection
  • Multiple device enrollment options as well as RF diagnostics ensure efficient and effective installation
  • Supports supervision of wireless points (504), keyfobs (1000), and repeaters (8)
  • External status LEDs
  • Detection and reporting of radio frequency interference
 

Features

BubbleLevel EasyInstall Indoor SDI2 Wireless
 
 
Ethernet Communication Module
  • Full two-way IP event reporting with remote control panel programming support
  • 10/100 Base-T Ethernet communication for IPv6 and IPv4 networks
  • NIST-FIPS197 Certified for 128-bit to 256-bitAES Encrypted Line Security
  • Plug and Play installation, including UPnP service to enable remote programming behind firewalls
  • Advanced configuration by browser, RPS, or A-Link
 
 
Plug-in Communicator, Telephone
  • Provides a single telephone line with RJ-45 connection for central station reporting and remote programming
  • Easily configured for communications from Remote Programming Software (RPS) or a keypad, eliminating the need for separate configuration
  • Easy two-step plug-in installation, troubleshooting, and maintenance
 
 
Dialer intercept communicator, Ethernet
  • Captures alarm and event data from dialer-based control panels using CONTACT ID, SIA, Modem II, Modem IIe, Modem IIIa2, Pulse, and other formats
  • Performs full data transmissions without changing the data
  • 12 VDC to 24 VDC voltage range
  • Re-routes signals using UDP/IP-based data networks
  • Convenient connection (RJ-45 Jack) to Ethernet networks
  • Integrated 10/100 Network Interface Module, or NIM
  • Provides acknowledgement from the receiver to the control panel
  • Supports 128-bit AES Rijndael encryption
 
 
Initiating module, dual class B, 12/24V
  • Two separate powered detector loops
  • Suitable for 12 VDC or 24 VDC, two‑wire or four‑wire detectors
  • Up to 50 two‑wire 12 VDC glass break detectors
  • Reports individual loop alarm, individual loop trouble, and ground fault
  • Manually resets latching devices from control panel or remote central station
 
 
Expansion module, Multiplex
  • Multiplex bus controls two independent buses
  • Aux Power terminals that can be used for remote devices
  • Programmed with D5060 Handheld Programmer (not required for "i" class modules)
  • Operation monitoring LED
  • Connect to Zonex 1 or Zonex 2
  • Standard three hole mounting
  • Accepts Daisy Chain and T-Tapping bus configurations
 
 
D9127 Series POPIT Modules
  • Provides point identification of initiating devices
  • Supervises wiring to devices for circuit integrity
  • Expands the number of points in the system
  • Compact size
  • Terminal connections for reliability
  • Multiplex technology
  • Low installation costs
 
 
USB/serial interface module
  • RS-232/USB connectivity
  • Enhanced direct connection for Remote Programming Software (RPS)
  • RJ-16 data bus
  • Transparent enclosure
  • Diagnostic light emitting diodes (LEDs)
  • DIP switches for address and bus programming